Townshend Audio Seismic Platform Isolation Shelf 43 x 30cm Expand

Townshend Audio Seismic Platform Isolation Shelf 43 x 30cm

Townsend Audio


Seismic Vibration Isolation Platform

    • Ultra thin platform disappears under equipment

    • Enhances clarity across the frequency range

    • Delivers wider and deeper soundstages

    • Improves bass definition

    • Reduced muddiness and smear

    • Makes transients clearer

More details

Delivery time 3-4 days



European Shipping

UK Delivery in 24h - 48h

Secure Payments

First Class service and security

Spend £150,00 more and get Free Shipping!

Free UK shipping if you spend over £150

Especially designed to isolate individual components such as CD players, turntables, DACs, preamplifiers, power amplifiers, computers and streamers from deleterious vibration.

The Seismic Isolation Platform includes a durable slim steel top plate that integrates unobtrusively under any hi-fi component.

The acoustically dead constrained-layer damped plate combined with a Seismic Load Cell™ attached to each corner is the ultimate combination to absorb and isolate unwanted vibration, including structural, air-borne and that generated by the hi-fi equipment.

The Seismic Isolation Platform is available in three standard sizes:

  • Size 1 43x30cm (17×12")
  • Size 2 48x35cm (19×14")
  • Size 3 52x40cm (20.5×16")

Platform working height is approximately 40mm (1.5")

The Platform can be levelled by turning the adjustable Seismic Load Cell™.

It is important to specify the weight of your equipment when ordering. Bespoke platforms are available for any size or weight of audio equipment.
Seismic Platforms are available with seven different weight range capacities, varying progressively from less than 1 kg up to 200kg.

The maximum load when using four ( 4) type "F" Load Cells is 200kg (440lb). For loads greater than this, simply add more Load Cells. Virtually any weight of equipment can be isolated.

Each Load Cell is screw adjustable in height to allow for out of balance loads where the centre of gravity of the component is not near its geometrical centre. If the level balance cannot be achieved, then it is suggested to use additional Seismic Pods positioned under the Platform as necessary, to balance the load.

For asymmetric components such as a valve (tube) amplifier with the transformers at the rear, different load capability Seismic Load Cells™ can be used to balance the load.

We suggest, for reasons of ease of set-up and loads that are not equally distributed, that consumers always select the stronger Load Cell where two values overlap in the graph below.

For example, when using four (4) type "C" Load Cells, the maximum supported weight should be equal to or less than 52.4 Kg.

No customer reviews for the moment.

Write a review



Site use cookies